To install the adapter software for Windows Server , do the following. Intel may make changes to the Software, or to items referenced therein, at any time without notice, but is not obligated to support or update the Software. You may not sublicense or permit simultaneous use of the Software by more than one user. You may copy the Software onto a single computer for your personal, noncommercial use, and you may make one back-up copy of the Software, subject to these conditions: Double-click the Gigabit Ethernet Adapter you want to configure. If not, do you see an EventID ?

Uploader: Fera
Date Added: 6 November 2011
File Size: 25.13 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 88220
Price: Free* [*Free Regsitration Required]

Please submit your comments, questions, or suggestions here. Once the adapter driver software has been installed, you can use this procedure to verify or change the following adapter properties: Namely, there’s one command you can run stated in the article to try and straighten this out:. The terms of the software license agreement included with any software you download will control your use of the software.

Has anything else been possibly altered, or installed on the DC?

By default, the adapter is set to Enable. If the device is busy doing something, however, servicing a call, for examplethe operating system will not shut down the device. Once installation of the driver software is complete, you are ready to modify configuration parameters. It is responsible for the QOS provisions on the local segment, and the avoidance of the “all packets are treated equally” issue, which falls onto the hub or switch servicing segment.


Any Updates on the Issue? One of them http: There are various bcm5708cc provided depending on your scenario.

It states a series of items to look for at the top of the article. Enabled by default, to disable Flow Control to receive, transmit, or receive and transmit PAUSE frames, select the appropriate parameter from the Advanced tab Value drop-down menu described and shown below.

The Wincows Mtu parameter allows the adapter to transmit and receive oversized Ethernet frames that are greater than but less than bytes in length.

This is the network speed when the system is in a standby mode awaiting wake up on Wibdows. Normally the TCP segmentation is done by the protocol stack.

Broadcom NetXtreme II 1 Gigabit Driver for Windows 32-bit

Have you looked at the links Miles provided? Double-click the Gigabit Ethernet Adapter you want to configure. Normally the Checksum Offload function is computed by the protocol stack. Set the speed as described and shown below: You may not export the Software in violation of applicable export laws and regulations.

Windows Server Driver Software: Broadcom NetXtreme Gigabit Ethernet Adapter User’s Guide

Claims arising under this Agreement shall be governed by the laws of California, excluding its principles of conflict of laws dindows the United Nations Convention on Contracts for 203 Sale of Goods. You may only distribute the Software to your customers pursuant to a written license agreement. By default, the adapter is set to Both.


Your comments have been sent. Remove From My Forums. Recently I installed my domain controler and have a seprate file server. You may transfer the Software only if the recipient agrees to be fully bound by these terms and if you retain no copies of the Software. See if any of them apply to your scenario or may work.

The operating system will try to shut down every possible wihdows only when it is hibernating. The Welcome to the Found New Hardware window then displays.

Once enabled, select Disable from the Advanced tab Value drop-down menu to disable this parameter.

By default, the adapter is set to Auto. For the file server, try the following. Set at bytes by default, to increase the size of the received frames, increment the byte quantity in byte increments from the Advanced tab Value counter, shown below.